2005 Arctic Cat ATVs factory service and repair manual, Page 466Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 466

5Install the actuator housing cover and secure with the screws6Connect the gas hose to the fuel pump; then connect the carburetor
as necessary10Turn the ignition switch to the ON position; then check the gas hose connections, float chamber seals, and
chamber vents for leaks 11Inspect the plunger assemblylstarter valve and seat for wear or damage12Inspect the carburetor
mounting flange for damage and tightness Cleaning and Inspecting Carburetor I NOTE: Whenever part is worn excessively, cracked,
or damaged in any way, replacement is necessary Throttle Cable Free-Play 1Check throttle cable free-play at the lever; free-play
should be as specified When drying components with compressed air, always wear safety glasses DO NOT place any non-metallic
components in parts-cleaning solvent because damage or deterioration will result 2To adjust, slide the rubber boot away from
the adjuster located near the throttle leverLoosen the jam nut and rotate the adjuster in the appropriate direction until