2005 Arctic Cat ATVs factory service and repair manual, Page 482Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 482

REMOVING 1Remove the radiator cap; then remove the water pump drain and drain the coolant 6Using an impact driver, loosen
inside the left-front wheel-well, remove the two tom-head cap screws securing the fender to the frame DISASSEMBLING 1Finish
removing the two Phillips-head cap screws securing the cover to the bearing housing; then remove the coverAccount for the
O-ring 2Remove the E-ring securing the impellerlshaft to the bearing housing; then remove the impellerlshaft5Compress the
tabs on the coolant hose clamps and slide the clamps away fi-om the hose ends approximately 51 mm (2 in; then remove both