2005 Arctic Cat ATVs factory service and repair manual, Page 483Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 483

CLEANING AND INSPECTING W NOTE: Whenever part is worn excessively, cracked, or damaged any way, replacement is necessary
bearing housing; then using seal driver7 gently tap the seal down until it is fully seated 1 cause serious-engine damage
Failure to properly engage the two shafts could 5With the bearing housing assembly in position on the engine, place the cover
(with O-ring installed) into position on the housing; then loosely secure with the two Phillips-head cap screwsINSTALLING
1Secure the water pump to the engine with the two cap screws tightened securely; then tighten the two Phillips-head cap screws
securely 2Place the new mechanical seal into the bearing housing; then tap it down until it is fully seatedW NOTE: large