2005 Arctic Cat ATVs factory service and repair manual, Page 485Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 485

2Remove the recoil starter (see Removing Left-Side Components in Section 3); then using suitable holding wrench (B) to hold
THIS POINT If the impeller is corroded or damaged, replace the impeller; then proceed to step 10If additional service on
the water pumplalternator cover is necessary, proceed to step 3 3Remove the alternator cover (see Removing Left-Side Components
in Section 3); then using suitable bearing driver, remove the water pump bearing fi-om the alternator cover4Press out the
mechanical seal (A) and oil seal (B) fi-om the inside of the alternator cover using bearing driver (C) 6Press ball bearing
(A) into the alternator cover fi-om the inside until it is bottomed; then using suitable socket (B) and bearing driver (C),