2005 Arctic Cat ATVs factory service and repair manual, Page 486Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 486

Testing Electric Fuel Pump (650 V-Twin) UAT THIS POINT S Prior to removing the electric fuel pump, the following check should
alternator cover (see Installing Left-Side Components in Section 3); then install the impeller and tighten clockwise to specifications
10Make sure that the alignment pins are correctly inserted; then using new gasket, install the water pump cover and tighten
the cap screws to specifications11Install the recoil starter (see Installing Lefl-Side Components Section 3)12Install the
coolant hoses onto the pump cover; then fill the cooling system with recommended coolant (see Section 2) 3Turn the ignition
switch to the ON positionThe fuel pressure should build until the pump shuts offPressure should read 0.18-0.23 kg-cm2 (2.6-3.3
psi) 4If the pump is not running, disconnect the fuel pumpltank sensor connector by reaching under the rear rack fi-om behind5Connect
multimeter to the power supply leads with the red tester lead to the brown wire and the black tester lead to the blacwred