2005 Arctic Cat ATVs factory service and repair manual, Page 487Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 487

WNOTE: To test the fuel gauge tank sensor, the fuel pump assembly must be removed REMOVING 5Lift out the fuel pump assembly
duct tape or other suitable means, cover the fuel pump openingINSPECTING THIS POINT If the pump has failed earlier test and
must be replaced, proceed to INSTALLING 1Inspect the fuel screen and blow clean with low pressure compressed air2Move the
float lever and check for fi-ee movementThe float assembly should return to the lower position without forceIf not, replace
the fuel pump assembly4Rotate the fuel pump assembly clockwise 90' to allow removal without removing the fuel tank 3Test
the fuel gauge tank sensor by connecting multimeter (A) to the fuel sensor leads (B); then select OHMSThe multimeter should