2005 Arctic Cat ATVs factory service and repair manual, Page 495Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 495

Brakelight Switch (Handlebar Control) 2Connect the red tester lead to one black wire; then connect the black tester lead
show battery voltageI NOTE: If the meter shows no battery voltage, troubleshoot the battery, fuse, switch, or the main wiring
harness 1Connect the meter leads (selector in the OHMS position) to the switch contacts2Suspend the switch and thermometer
in container of oil; then heat the oilI NOTE: Neither the switch nor the thermometer should be allowed to touch the bottom
of the container or inaccurate readings will occurUse wire holders to suspend switch and thermometerTemperatureCooling Fan
Switch Leads main wiring harness good; proceed to test the switchlcomponent, the connector, and the switch wiring harness
for resistance I NOTE: If the meter shows battery voltage, the RESISTANCE (Switch Connector) wire Holders Always disconnect
the battery when performing resistance tests to avoid damaging the1 multimeterI NOTE: The brake lever must be compressed
for this testAlso, the ignition switch must be in the OFF position Thermometer 1Set the meter selector to the OHMS position