2005 Arctic Cat ATVs factory service and repair manual, Page 496Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 496

3On the oil temperature switch when the oil temperature reaches 160' (320' F), the meter should read closed circuit4On the
should read an open circuit7If the readings are not as indicated, the switch must be replaced8Install the switch and tighten
securely9Connect the switch leads 7If the readings are not as indicated, the switch must be replaced8Apply thread tape to
the threads ofthe switch; then install the switch and tighten securely9Connect the switch leads Fan Motor (40015001650 H11650
V-Twin) Coolant Temperature and Cooling Fan Switches (5001650 H11650 V-Twin) To access the connector (located directly behind
the fan), the front rack and front fenders must be removed (see Section 8)IThe ignition switch must be in the ON position
1Connect the meter leads (selector in the OHMS position) to the switch contacts2Suspend the switch and thermometer in container
of water; then heat the waterINeither the switch nor the thermometer should be allowed to touch the bottom of the container