2005 Arctic Cat ATVs factory service and repair manual, Page 499Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 499

2Connect the red tester lead to the whitelblue wire; then connect the black tester lead to ground3The meter must show IV
rotor and magnets, magneto rotor key, or the CDI unit RESISTANCE 2The meter reading must be within specificationSecondary
Winding Always disconnect the battery when resistance tests to avoid damaging multimeterI NOTE: For these tests, the meter
selector should be set to the OHMS position 1Connect the red tester lead to the high tension lead (plug cap removed); then