2005 Arctic Cat ATVs factory service and repair manual, Page 500Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 500

1Set the meter selector to the D.CVoltage position; then disconnect the bluelwhite primary wire from the coil2Connect the
then disconnect the bluelwhite primary wire from the coil2Connect the red tester lead to the primary wire; then connect the
black tester lead to ground 3Crank the engine over using the electric starter4The meter reading must be within specificationPEAK
VOLTAGE (5001650 I1650 V-Twin) 2The meter reading must be within specificationI NOTE: If the meter does not read as specified,
replace the spark plug cap INOTE: All of the peak voltage tests should be made using the Fluke Model 73 Multimeter (pin 0644-191)
with Peak Voltage Reading Adapter (pin 0644-307)any other type of tester is used, readIf ings may vary due to internal circuitryINOTE:
The battery must be at full charge for these tests PEAK VOLTAGE (2501300) INOTE: All of the peak voltage tests should be
made using the Fluke Model 73 Multimeter (pin 0644-191) with Peak Voltage Reading Adapter (pin 0644-307)any other type of