2005 Arctic Cat ATVs factory service and repair manual, Page 501Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 501

REVERSE POSITION LIGHT Indicator Lights (250300400 ACT) 1Connect the jumper positive wire to the power source terminal on
procedure After testing procedures are completed, use the following procedure 1Connect the indicator light connector to the
main wiring harness2Pull the instrument pod wiring with light bar upward and install the light bar into the instrument pod
1Remove the three machine screws and key cover securing the instrument pod2Remove the light bar from the instrument pod;
then cut the cable tie securing the instrument pod wiring to the steering post 3Push the instrument pod wiring with light
bar downward to access the indicator light connector; then disconnect the connector from the main wiring harnessIFor these
tests, 12-volt power supply "jumper" should be used to supply power 3Secure the instrument pod with existing hardware; then
secure the instrument pod wiring to the steering post using cable tieHI BEAM INDICATOR VOLTAGE IThe ignition switch must
be in the LIGHTS positionAlso, the dimmer switch must be in the HI position, and the test must be performed on the lower