2005 Arctic Cat ATVs factory service and repair manual, Page 502Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 502

Disconnect the white oil temperature switch connector from the switch (on the top right side of the engine) and ground the
the engineConnect the red tester lead to the redlblack wire from the fan temperature switch; then connect the black tester
lead to the violet wire from the water temperature switchThe meter must show battery voltageNEUTRAL POSITION VOLTAGE INOTE:
The ignition switch must be in the ON positionAlso, the shifter must be in the NEUTRAL position, and the test must be performed
on the lower side of the connection 1Set the meter selector to the D.CVoltage position2Connect the red tester lead to the
redlblack wire; then connect the black tester lead to the bluelwhite wire 3The meter must show battery voltageREVERSE POSITION
VOLTAGE INOTE: The ignition switch must be in the ON positionAlso, the reverse lever must be the REVERSE position, and the
test must be performed on the lower side of the connector 1Set the meter selector to the D.CVoltage position2With appropriate