2005 Arctic Cat ATVs factory service and repair manual, Page 509Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 509

2With the dimmer switch in the LO position, the meter must show an open circuitI NOTE: If the meter reads resistance, troubleshoot
lead to the yellowlgreen wire; then connect the black tester lead to the orangelwhite wireWith the starter button depressed,
the meter must show an open circuitI NOTE: If the meter does not show as specified, replace the switchcomponent, connector,
or switch harness Front Drive Selector Switch (400 FISl5001650 H11650 V-Twin) The connector is the two-wire black snap-lock
one in front of the steering postTo access the connector, the front rack and front fenders must be removed (see Section 8)I
NOTE: Resistance tests should be made with the connector disconnected and on the selector-side of the connector RESISTANCE
(Emergency Stop) Set the meter selector to the OHMS positionConnect the red tester lead to the orange wire; then connect
the black tester lead to the orangelwhite wireWith the switch in the OFF position, the meter must show an open circuitWith
the switch in the RUN position, the meter must show less than ohmIIf the meter shows more than ohm of resistance, troubleshoot