2005 Arctic Cat ATVs factory service and repair manual, Page 510Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 510

3Connect the red tester lead to the red wire on the harness side of the connector4Turn the ignition switch to the RUN position5The
on the actuator wiring harnessWith the ignition switch in the OFF position, connect the black tester lead to the black wire
in the supply harness; then connect the red tester lead to the orange wire in the supply harnessTurn the ignition switch
to the ON positionThe meter must show 12 D.CvoltsConnect the red tester lead to the whitelred wire in the supply harnessThe
meter must show 12 D.CvoltsSelect the 4WD position on the front drive selector switch; then connect the red tester lead to
the whitelred wire in the supply harnessThe meter must show D.CvoltsConnect the red tester lead to the orange wire in the
supply harnessThe meter must show 12 D.CvoltsINOTE: If the voltage readings are as specified and the actuator does not function
correctly, replace the actuator (see Section 6) 2Turn the ignition switch to the ON positionThe meter must show 12 D.CvoltsI