2005 Arctic Cat ATVs factory service and repair manual, Page 511Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 511

3With the engine running at the specified RPM, all wire tests must show 60 A.Cvolts A CAUTION Do not run the engine at high
the negative battery post3With the engine running at constant 5000 RPM (with the headlights on), the meter must show 14-15.5
D.Cvoltsdisconnect the battery when performing tests to avoid damaging the1 1Set the meter selector to the OHMS position2On
the 2501300, connect the red tester lead to the blackyellow wire; then connect the black tester lead to the greedwhite wireThe
meter reading must be within specification3On the 40015001650 HI, connect the red tester lead to the green wire; then connect
the black tester lead to the blue wireThe meter reading must be within specificationRESISTANCE (Source Coil 400500650 ) Do
not run the engine at high RPM for more than 10 secondsIIf voltage is lower than specified, test charging coilno load VOLTAGE
(Charging Coil The connector is the black and white one on the right side of the engine just above the brake cable adjusterI
NOTE: Test the connector that comes from the engine 1Set the meter selector to the OHMS position2Connect the red tester lead