2005 Arctic Cat ATVs factory service and repair manual, Page 513Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 513

RESISTANCE (Charging Coil) Magneto Coils (650 V-Twin) VOLTAGE (Charging Coil Always disconnect the battery when performing
to avoid damaging the1 multimeter 2Test between the three black wires for total of three tests 1Set the meter selector to
the OHMS position2Connect the red tester lead to the blacldwhite wire; then connect the black tester lead to the blue wireThe
meter reading must be within specificationPEAK VOLTAGE WNOTE: All of the peak voltage tests should be made using the Fluke
Model 73 Multimeter (pin 0644-191) with Peak Voltage Reading Adapter (pin 0644-307)If any other type of tester is used, readings
may vary due to internal circuitryWNOTE: The battery must be at full charge for these tests 3With the engine running at constant
3000 RPM, all wire tests must be within specifications Magneto Coil (Trigger) 1Set the meter selector to the D.CVoltage position
not run the engine at high RPM for more than W NOTE: If both charging coil tests failed, check all connections, etc and test
againIf no voltage is present, replace the stator assemblyPage: 513 Arctic Cat ATV 2005 -All Models 2Connect the red tester