2005 Arctic Cat ATVs factory service and repair manual, Page 515Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 515

CLEANING AND INSPECTING W NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
length of the bmshesIf bmsh measurement is less than 10.1 mm (0.40 in, replace with new brushes and bmsh spsings as set4Inspect
the brush leads for cracks, wear, or fiayingIf any of these conditions exist, replace with new bmshes and bmsh spsings as
set 5Inspect the rear cover bushing for wear6Inspect the fiont cover beasing for wear11Remove the positive bmsh assembly
fiom the starter housing7Inspect the brass commutator end of the armature for any busned spots or damageIf the commutator
is lightly busned or damaged, the armature must be replacedThis is molded commutator and tuning it down in lathe should not