2005 Arctic Cat ATVs factory service and repair manual, Page 519Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 519

INOTE: The ignition switch must be in the ON position, the emergency stop switch in the RUN position, the reverse lever (on
ground connectionsI NOTE: If the meter showed no battery voltage, inspect the main fuse, ground connections, starter motor
lead, battery voltage (at the battery), starter relay, or the neutral start relay Starter Relay (2 501300) RESISTANCE 10Apply
small amount of grease to the O-ring seal on the starter; then install the starter into the crankcaseSecure with two cap
screws and wiring forms11Secure the positive cable to the starter with the nut12Connect the batteryTESTING VOLTAGE Always
disconnect the battery when performing resistance tests to avoid damaging the multimeter 1Disconnect the battery; then verify
that the ignition fuse is goodDisconnect all wires from the solenoid 2Set the meter selector to the OHMS position Perform
this test on the starter motor positive terminalTo access the terminal, slide the boot awayPage: 519 Arctic Cat ATV 2005