2005 Arctic Cat ATVs factory service and repair manual, Page 520Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 520

Starter Relay (400 ACT) I NOTE: Leave the tester leads connected to the solenoid posts for the following procedure INOTE:
procedureINOTE: An external 12-volt power supply "jumper" (positive and negative connections) must be used for this testAlso,
it is very important that the meter leads and power supply connections are made to the appropriate terminals of the relay
or damage to the multimeter will result INOTE: If there was no audible "click" from the relay or if the meter shows more
than ohm, it must be replacedIf there was "click," continue to test resistance 6With the 12-volt power supply disconnected,
connect the tester leads to each small terminal of the solenoid7The meter must show 4.3 ohms 20INOTE: If the meter shows
no resistance, the relay is out of tolerance or it must be replaced 5Connect the power supply (positive) to terminal #3;
then connect the power supply (negative) to terminal #4There should be an audible "click" from the relay, and the meter must
show less than ohmINOTE: If there was no audible "click from the relay or if the meter shows more than ohm, it must be replacedIf