2005 Arctic Cat ATVs factory service and repair manual, Page 521Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 521

8With the 12-volt power supply disconnected, connect the red tester lead to terminal #3; then connect the black tester lead
cause for electrical problems; however, if the CDI is suspected, substitute another CDI unit to verify the suspected one
is defectiveI NOTE: Prior to replacing the CDI unit to assure the CDI unit is defective, it is advisable to perform CDI peak
voltage test (see Ignition Coil in this section) andor perform continuity test of the wiring harness from the CDI connector
to the CDI unit INOTE: Make sure that the ignition switch is in the ON position, transmission in neutral, brake lock released,
and the emergency stop switch in the RUN position 3Depress the starter button while observing the multimeterThe multimeter
should drop to volts and "click" should be heard from the relayindicated by the multimeter, replace the starter relayIf no
"click" is heard and the multimeter continues to indicate battery voltage, proceed to step 4I NOTE: If "click" is heard and