2005 Arctic Cat ATVs factory service and repair manual, Page 523Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 523

Neutral Start Relay (400 ACT) 2Connect the power supply (positive) to one copper terminal; then connect the power supply
red tester lead to one brass terminal; then connect the black tester lead to the other brass terminal5The meter must show
less than ohmI NOTE: If the meter shows more than ohm (even 4With the black tester lead still connected to ground, connect
the red tester lead to the yellowlgreen wire5Depress the starter buttonThe meter must show battery voltageINOTE: If the meter
shows no battery voltage, inspect fuses, wiring harness, connectors, and switches thouuh the "click" was heard in the Dower
SUDDIV test),the relay must be replaced RESISTANCE (Relay Copper Terminals) RESISTANCE (Relay Brass Terminals) Always disconnect
the battery when performing resistance tests to avoid damaging the multimeterINOTE: The external power supply will not be
used for this test Always disconnect the battery when performing resistance tests to avoid damaging the multimeter 1Set the