2005 Arctic Cat ATVs factory service and repair manual, Page 524Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 524

Headlights The connectors are the two 3-prong ones secured to the front bumper supports (one on each side) with cable tiesBULB
the taillight or brakelight fails to illuminate, inspect the bulb, the connectors, or the component wiring harness 3The bulb
should illuminate4If the bulb fails to illuminate, it must be replacedVOLTAGE I NOTE: Perform this test in turn on the main
harness side of all four connectorsAlso, the ignition switch must be in the LIGHTS position VOLTAGE (Taillight) INOTE: Perform
this test on the main harness side of the connectorAlso, the ignition switch should be in the LIGHTS position I NOTE: The
LO beam is the outside bulb, and the HI beam is the inside bulb 1Set the meter selector to the D.CVoltage position1Set the
meter selector to the D.CVoltage position 2Connect the red tester lead to one wire; then connect the black tester lead to
the other wire3With the dimmer switch in the LO position, test the two outside connectors (LO beam)The meter must show battery
voltage4With the dimmer switch in the HI position, test the two inside connectors (HI beam)The meter must show battery voltageinspect