2005 Arctic Cat ATVs factory service and repair manual, Page 526Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 526

V-Belt Failure Mode Clearing (650 V-Twin) 100-Hour Belt Inspection Mode Clearing (650 V-Twin) PROCEDURE I NOTE: See Section
or more; then turn the ignition switch to OFFthen it will flash slowlyAllow the light to flash slowly for at least seconds
before turning the ignition switch offI NOTE: The light will flash rapidly for seconds; 3Disconnect the belt indicator light
switch connectorThe light should flash slowlyAllow the light to flash for 10 seconds before turning the ignition switch off4Turn
the ignition switch to the OFF position; then remove the reset connector5Connect the 4-pin connector and the belt indicator
light switch connector; then turn the ignition switch to the ON positionThe belt indicator light should go off 3Remove the
reset connector and connect the 4-pin connectors and the belt indicator light switch connector4Turn the ignition switch to
the ON position and confirm that the belt indicator light goes off Engine Brake Actuator Resistance (650 V-Twin) I NOTE:
This component is located on the V-belt cover and controls drive clutch disengagement through lever linkage 1Remove the air