2005 Arctic Cat ATVs factory service and repair manual, Page 528Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 528

3After two seconds, observe the meter until the actuator stopsThe controller output voltage should vary from 5- 12 D.CvoltsIf
on the left side of the engine and provides vehicle direction data to the engine brake controller Always disconnect the battery
when performing resistance tests to avoid damaging the1 multimeter 1Disconnect the sensor lead wire connector (A); then select
OHMS on the multimeter and check resistance between the sensor pinsThe meter should read 1200-1600 ohms2Check each lead of
the sensor to groundThe meter should show an open circuit or infinity (:)If either test fails, replace the sensor (B) Output-to-Speed
Sensor Voltage (650 V-Twin) Select D.CVoltage on the multimeter (B), disconnect the speed sensor connector, and turn the
ignition switch ON; then connect the red meter lead to the pinldwhite wire terminal (5) and the black tester lead to the