2005 Arctic Cat ATVs factory service and repair manual, Page 529Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 529

Speed Sensor Signal Voltage (650 V-Twin) Tilt Sensor Voltage (650 V-Twin) IThis component is located on the right side of
the three-wire connector from the sensor; then select D.CVoltage on the multimeter and connect the red tester lead to the
orange wire (C) and the black tester lead to the black wire (A) 3Spin rear wheel in the forward direction while observing
the multimeterThe meter should alternately show volts and D.CvoltsIf the reading is not as specified, replace the speed sensor
! Turn the ignition switch to the ON positionThe multimeter should read battery voltageIf battery voltage is not indicated,
check the 30-amp fuse, wiring harness, or the ignition switch 3Remove the red tester lead and connect to the bluehrown wire
(B)The multimeter should read 5.0 D.CvoltsIf the specified voltage is not indicated, check wire connections at the CDI or