2005 Arctic Cat ATVs factory service and repair manual, Page 530Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 530

OUTPUT VOLTAGE multimeter leads as the following tests are made with the sensor connectedI NOTE: Needle adapters will be
1Connect the three-wire plug to the sensor; then remove the right-side mounting screw securing the sensor to the rear frame
I NOTE: When replacing the sensor after testing, make sure the arrow marking is directed upCD707 2Install the needle adapters
to the multimeter leads; then select D.CVoltage on the multimeter3Connect the red tester lead to the bluebrown wire (B) and