2005 Arctic Cat ATVs factory service and repair manual, Page 545Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 545

SPECIAL TOOLS Drive System in this section are used for clarity purposes only and are not designed to depict actual conditionsI
into the housing; then use the following torque valuessize M6 (Torx T-30 Recess) M8 (TOMT-40 Recess) MI0 (Torx T-50 Recess)
If noise is heard from the gear case area, it can be difficult to locate andor diagnoseIf the noise is related to wheel speed,
but not to engine RPM, the problem is probably in the final drive or enginetransmission bevel gear setWhen problem is localized,
number of inspections must be made to pinpoint that problemThe most obvious ofthe inspections include CV boots, wheel and
hub nut tightness, wheel bearing damage, gear case lubricant contamination, low lubricant level, seal leakage, CV joints,
or selector armI NOTE: Small metallic particles will collect on the magnetic drain plug as normal part of break-in and will
also give metallic cast to drained lubricantContamination would include large particles or water which gives "milky" look