2005 Arctic Cat ATVs factory service and repair manual, Page 546Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 546

4Loosen but do not remove the mounting cap screw Front Drive Actuator ( FISl5001650 H11650 V-Twin) I NOTE: The actuator is
sounds, the actuator must be replacedREMOVING INSTALLING 1Lubricate the O-ring on the actuator; then ensure that all mounting
surfaces are clean and free of debris 1Remove the left-front inner fender panel; then disconnect the connector on the actuator
harness2Using T-30 torx wrench, remove the mounting cap screw from the driveshaft side of the actuator 2Alien the actuator
with the selector shaft and slide it forward onto the shaft taking care to engage the cap screw in the slot of the front
mounting tab$8 3Remove the mounting cap screw from below the actuator on the suspension side 3While holding the actuator
firmly forward, tighten the front cap screw to hold the actuator in place; then install but do not tighten the two remaining