2005 Arctic Cat ATVs factory service and repair manual, Page 547Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 547

4Loosen the front cap screw; then tighten the cap screw on the driveshaft side Front Differential View from Beneath ATV0082
harness to the frame with nylon cable tie; then install the inner fender panel Front Differential (FIS Models) 6Release the
brake lever lockINOTE: To remove the rear gear case on 400 FISl500 models, see Rear Gear Case (400 FISl500 Models) in this
sectionINOTE: It is not necessary to remove the brake hoses from the calipers for this procedure REMOVING DIFFERENTIAL 1Secure
the ATV on support stand to elevate the wheels 7Remove the two brake calipersAccount for the four cap screws and four 0.76
mm (0.030 in spacer washers Make sure the ATV is solidly supported on the support stand to avoid injury 2Remove the drain