2005 Arctic Cat ATVs factory service and repair manual, Page 552Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 552

5On the 400 FISl5001650 HI, place the pinion housing with new gasket onto the gear case housing; then secure with the existing
400 FISl5001650 HI, install the input shaft into the housing; then install the front boot and secure with Boot Clamp (pln
0423-393) and the rear boot with Boot Clamp (pln 0423-411) 7On the 650 V-Twin, place the pinion housing with new gasket onto
the gear case housing; then secure with existing cap screwsTighten to specificationsIIf new gear case housing is being installed,