2005 Arctic Cat ATVs factory service and repair manual, Page 558Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 558

9Install the left bearing housing aligning the match mark to the mark on the differential housing 11Making sure the O-ring
needle bearing is rarely necessaryAvoid removing the needle bearing unless the bearing is clearly damaged 10Install the differential
lock assembly into the bearing housing; then place the O-ring on the gear case housing INOTE: This procedure can be performed
on rear gear case- 1Place 6.35 mm (114 in drill bit on the inside surface of the needle bearing (against the bottom side);