2005 Arctic Cat ATVs factory service and repair manual, Page 559Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 559

3Using flat-nosed punch, drive the bearing out of the housing 3Install the pinion shaft and secure with the existing 48 mm
stake the lock collar to ensure that the collar will remain securely tightened 2Using suitable driver, install the needle
bearing into the gear case housing making sure the bearing is seatedI NOTE: Do not push the bearing too far into the 5Install
the pinion housingRemovingIInstallingAxle Seal IThis procedure can be performed on rear gear case housing 1Remove the seal