2005 Arctic Cat ATVs factory service and repair manual, Page 562Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 562

INOTE: Do not allow the brake calipers to hang from their cablelhose The calipers should be supportedIf the calipers are
nut Make sure the ATV is solidly supported on the support stand to avoid injury 2Pump up the hand brake; then engage the
brake lever lock 8While holding the drive axle stationary, pull the top of the knuckle out and down until it is free of the
drive axle9Place drain pan under the ATV to contain any oil leakage; then using slide hammer, remove the drive axle 3Remove
the wheel 4Remove the cotter pin securing the hex nut; then remove the hex nutRelease the brake lever lock REMOVING FRONT
DRIVE AXLE (4x4 Models) I NOTE: For removing front drive axle on 4x4 model, see Front Differential (FIS Models) in this section