2005 Arctic Cat ATVs factory service and repair manual, Page 563Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 563

CLEANING AND INSPECTING I NOTE: Always clean and inspect the drive axle components to determine if any service or replacement
substitute), remove the large clamp from the boot 4Note the difference inside each bearing ring end for assembling purposes;
then remove the bearing ringI NOTE: The recess of the bearing must face toward the housing 2Wipe away excess grease to access
the retaining ringUsing an awl or circlip pliers, remove the circlip 5Inspect the splines of the shaft, the bearing ring,
and the housing for damageI NOTE: If any damage is apparent to the splines, the bearing ring, andor the housing, the drive