2005 Arctic Cat ATVs factory service and repair manual, Page 565Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 565

I NOTE: The boot is positioned correctly when the small end of the boot seats down into the recessed groove 5Secure the bearing
bearing is packed properly 3Apply 80 grams (213 of contents) of grease from the pack into the bearing housing4Install the
bearing onto the shaft making sure the recess of the bearing is facing the housing 7Slide the boot over the housing; then
using the boot clamp pliers, secure the boot with the clamp bearing ring must go onto the shaft with the without splines
facing toward the small of the inner boot or severe damage will 8Inspect the axle components for correct positioning of the