2005 Arctic Cat ATVs factory service and repair manual, Page 566Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 566

INSTALLING REAR DRIVE AXLE (Fully Independent Suspension) 1Slide the drive axle into place in the gear caseI NOTE: To assure
then pump up the hand brake lever and engage the brake lever lock6Tighten the hub hex nut (from step 4) to specifications;
then install and spread new cotter pin making sure each side of the pin is flush to the hub nut 4If the brake calipers were
removed, position them on the knuckle and secure with existing cap screwsTighten the auxiliary brake caliper cap screws to
specificationsTighten the hydraulic brake caliper cap screws to specifications5Pump up the hand brake lever; then engage
the brake lever lock 6Tighten the hub hex nut (from step 3) to specifications; then install and spread new cotter pin making
sure each side of the pin is flush to the hub nut 7Install the wheel and tighten to specifications 8Remove the ATV from the
support stand and release the brake lever lock9Check the front differential oil level and add oil as necessary 7Install the
wheelTighten to specifications Front Differential 8Remove the ATV from the support stand and release the brake lever lockINSTALLING