2005 Arctic Cat ATVs factory service and repair manual, Page 569Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 569

CLEANING AND INSPECTING I NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
4Lightly grease the bearing housing seal; then slide the bearing housing onto the axle shaftSecure with the snap ring 1Grease
the splines of the ring gear2Make sure the rear gear caselaxle housing O-ring is properly positioned; then secure the axle
housing to the rear gear case with two 33 mrn (1.3 in cap screwsTighten to specificationsIIf new gear case is being installed,
tighten the cap screws to 5.1-6.3 kg-m (37-45.5 ft-lb) 5Place the axle gasket on the axle housingRotate the axle shaft slightly
to ensure proper engagement with the gear case splines Rotate the bearing housing until the brake caliper mounting holes
are on the top side; then secure the axle retainer assemblylaxle assembly to the axle housing with four cap screwsTighten