2005 Arctic Cat ATVs factory service and repair manual, Page 572Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 572

INSTALLING Rear Gear Case (FIS Models) REMOVING 1Slide the gear case into position through the left side of the fi-ame; then
(coated with red Loctite #271) and lock nutsTighten to specifications 3Install the rear drive axles (see Drive Axles in this
section) 4Install the left-side rear A-arms (see Rear A-Arms in Section 7) REMOVING 4Remove the two cap screws and lock nuts
securing the rear gear case to the frame; then remove the gear case through the left side 1Secure the on support stand to
elevate the wheel; then remove the wheel 1 support stand to avoid injury: 2Remove the cotter pin fi-om the nut W NOTE: During
assembly, new cotter pins should be installed AT THIS POINT For servicing the input shaft, pinion gear, needle bearing, and