2005 Arctic Cat ATVs factory service and repair manual, Page 573Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 573

5Remove the hub assembly 6Remove the four cap screws securing the brake discCLEANING AND INSPECTING NOTE: Whenever part
brake disc for cracks or warping4Inspect the hub for pits, cracks, loose studs, or spline wearINSTALLING 1Secure the brake
disc to the hub with the four cap screws coated with blue Loctite #243Tighten to specifications 2Apply grease to the splines
in the hub 6Tighten the hub nut (from step 4) to specifications; then install and spread new cotter pin making sure each
side of the pin is flush to the hub nut Install the hub assembly onto the shaft 7Install the wheel and tighten to specifications