2005 Arctic Cat ATVs factory service and repair manual, Page 584Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 584

Swing Arms (ACT REMOVING - Rear Suspension) 1Remove the cap screws and lock nuts securing the front of the swing arms to
grommets from the hose guides 2Place bushings and sleeves (where appropriate) into shock eyelet; then install shock with
two cap screws and nutsTighten all nuts to specifications 4Remove the swing arms and note the location of the hose guides
on the inner swing arm (for installing purposes)CLEANING AND INSPECTING not tighten the nuts beyond the 4.8 kg-m (35 specification
or the shock eyelet or mount I NOTE: Whenever part is worn excessively, cracked, or damaged in any way, replacement is necessary
models, the rear shock absorber-to-lower A-arm torque factor is 2.8 kg-m (20 ft-lb) I NOTE: On the fully independent rear
suspension 1Clean all swing arm components in parts-cleaning solvent2Inspect all swing arm weldments for cracks or unusual
bends 3Remove the ATV from the support stand 3Inspect all tubing for cracks or unusual bendsINSTALLING 1On the right side,