2005 Arctic Cat ATVs factory service and repair manual, Page 585Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 585

3Secure the two right side swing arms to the frame brackets with cap screws and hex nutsDo not tighten at this time4On the
wheels 7Remove the cap screws securing the ball joints to the knuckle Make sure the ATV is solidly supported on the support
stand to avoid injury- 2Remove the cotter pin from the nutDiscard the cotter pin Support the knuckle when removing the cap
screws or damaae to the threads will occur 3Remove the nut securing the hub4Remove the brake caliperAccount for two cap screws
and two 0.76 mm (0.030 in spacer washers 8Tap the ball joints out of the knuckle; then remove the knuckle9Remove the lower