2005 Arctic Cat ATVs factory service and repair manual, Page 586Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 586

11Remove the circlip from the ball joint; then remove the ball joint from the A-arm 2Install the A-arm assemblies into the
ball joint mounting holes for cracks or damage 5Inspect the frame mounts for signs of damage, wear, or weldment damageINSTALLING
4Secure the lower eyelet of the shock absorber to the upper A-armTighten nut to specifications 1Apply green Loctite #609
to the entire outside diameter of the ball joint; then install the ball joint into the A-arm and secure with the circlip
5Secure the A-arm assemblies to the frame mounts (from step 2)Tighten the cap screws to specifications A CAUTION Do not tighten