2005 Arctic Cat ATVs factory service and repair manual, Page 597Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 597

9Remove the cotter pins and slotted nuts from the inner and outer tie rod ends; then remove the tie rods from the steering
welded deterioration 5Inspect the steering post and steering-post brackets for cracks, bends, or wearm 6Inspect the bearing
halves, bearing caps, and bearing housings for cracks or wear 7Inspect the handlebar tube for cracks, wear, or unusual bends#
8Inspect the handlebar grips for damage or wearINSTALLING (250300400 FISIACT) 10Remove two cap screws securing the lower
steering post bearing flange to the frame; then remove the steering post 1Place the steering post into position; then place
the upper steering post bearings and housings on the steering post and install the two cap screws through the housings and