2005 Arctic Cat ATVs factory service and repair manual, Page 600Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 600

8Install the steering post access cover and secure with four reinstallable rivets; then install and secure the radiator access
secure with two reinstallable rivets and the ignition switch locking ring INSTALLING I NOTE: Before installing grip, use
contact spray or alcohol to clean the inside of the grip and the handlebar of glue residue, oil, or any other contaminant
1Apply liberal amount of Handlebar Grip Adhesive (pln 0636-07 1) to the inside of the grip 2Align the rivet hole in the grip
with the rivet hole in the handlebar; then align the notch (inside the grip) with the slot in thehandlbar and slide the grip
onto the handlebar until it is fully seated3Wipe off any excess glue; then secure the grip with new rivet 4Install the plug