2005 Arctic Cat ATVs factory service and repair manual, Page 601Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 601

10Remove the bearing retainer Steering Knuckles REMOVING AND DISASSEMBLING 1Secure the ATV on support stand to elevate the
securing the ball joints in the knuckleTap the ball joint end out of the knuckle; then remove the knuckleRemove the seal
from the knuckle 11Remove the bearings Use extreme care when removing the bearingIf the bearing is allowed to fall, it will
be damaged and will have to be replaced CLEANING AND INSPECTING I NOTE: Whenever part is worn excessively, cracked, or damaged
in any way, replacement is necessary 1Clean all knuckle components2Inspect the bearing for pits, gouges, rusting, or premature