2005 Arctic Cat ATVs factory service and repair manual, Page 617Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 617

5Connect the wiring to each of the headlights Front Fender1 Side Panels (250300400 FISIACTITRW REMOVING 7Remove the fi-ont
bosses for stripping4Inspect the wiring harness and headlights for damage 5Inspect the screen for damage or air-flow obstructionsINSTALLING
1Place the fi-ont bumper assembly into position on the kame and securiwith four ciP Tighten securely 2Secure the front skid
plate to the fi-ont bumper with the four cap scyewsTighten securely3Place the two fender extension studs through the fi-ont
bumper and secure with the existing push nuts 4Remove the three machine screws securing the gear shift linkage cover to the
fender and remove the coverWNOTE: The cover is located inside the left-front 5Remove the nut securing the drive selector