2005 Arctic Cat ATVs factory service and repair manual, Page 618Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 618

8Disconnect the wires from the accessory plug (if equipped); then remove the accessory plug fi-om the fender9Remove the fenders
fenders into position on the ATV2Install the accessory plug (if equipped) into the fender; then connect the two accessory
plug wiresW NOTE: The accessory plug red wire goes on the center connector 3Install the cap screws (five per side) securing
the fenders to the fi-ame and footrests and finger-tighten; then tighten the ten fasteners securely 4Connect the drive selector