2005 Arctic Cat ATVs factory service and repair manual, Page 624Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 624

4Tighten the 10 mm footrest cap screws (from step 2) to specifications; then tighten the mm cap screws (from step 2) to specifications5Connect
is worn excessively, cracked, or damaged in any way, replacement is necessary 3Install plastic rivets, cap screws, and flange
nuts securing the front and rear fenders to the footwells Belly Panel REMOVING 1Clean the footrest in parts-cleaning solvent
2Inspect the footrest weldments for cracks or unusual bends 3Inspect all tubing for cracks or unusual bendsINSTALLING (250300400
FISIACT) 1Remove the machine screws and shoulder washers securing the belly panel to the underside of the frame 2Remove the
belly panelINSTALLING 1Connect the foot brake cable to the brake pedal (right-side footrest) 2Place the footrest into position
on the frame and loosely secure with the four cap screws 1Place the belly panel into position on the underside of the frame2Install