2005 Arctic Cat ATVs factory service and repair manual, Page 626Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 626

Rear Fender (25013001400 FISIACT) REMOVING ARoute the battery cables, fuse panel wiring, and vent hose into the fender through
ARemove the battery hold-down and tool kit and disconnect the battery cables (negative cable first) and the vent hose; then
remove the battery 6Install the side panels (see Front FenderISide Panels in this section)7Install the rear rack (see Rear
Rack in this section) BRemove the two screws securing the fuse panel to the fender; then disconnect all wires from the back
of the panel 8Install the seat (see Seat in this section) CRoute the battery cables, fuse panel wiring, and vent hose out
of the fender through the hole at the bottom of the battery compartment Rear Body PanelIRack (5001650 H11650 V-Twin) REMOVING
6Disconnect the taillight wiring harness three-prong connector; then remove the fenderCLEANING AND INSPECTING cracked, or
damaged in any way, replacement is necessaryI NOTE: Whenever part is worn excessively, 1Remove four machine screws and flanged
nuts securing the rear rack; then remove the rear rackAccount for four bushings 1Clean all rear fender components with soap