2005 Arctic Cat ATVs factory service and repair manual, Page 630Get this manual

2005 Arctic Cat ATVs factory service and repair manual, Page 630

6Observe each headlight beam aimProper aim is when the most intense beam is centered on the vertical mark cm (2 in below
AHorizontalLoosen nut (A) and adjust for proper aimingTighten the nut securelyBVerticalLoosen nut (B) and adjust for proper
aimingTighten the nut securely 1Unplug the three-prong connector and free the taillight wiring harness from the frame2Remove
the tom-head cap screws securing the taillight assembly to the frameAccount for any washers CTurn the adjustment knob counterclockwise
to lower the beam and clockwise to raise the beam 3Remove the taillight assemblyINSPECTING I NOTE: Whenever part is worn
excessively, cracked, or damaged in any way, replacement is necessary 1Inspect wiring harness, three-prong connector, lens,
base, cap screws, and socket for damage2Inspect all wires for corroding, pinching, and crackingPage: 630 Arctic Cat ATV 2005